Getting Started With The Transmitter; Inserting Batteries - Reely 1576770 Bedienungsanleitung

9. Getting started with the transmitter

The numbers used in these instructions refer to the illustration alongside the text or the illustrations within
the respective section. Cross references to other figures are indicated with the corresponding number.
a) Inserting batteries
For the power supply to the transmitter, you will need 4 AA/Mignon batteries (e.g. Conrad item no. 652504, 4 pack,
order 1x).
Important:
Use only standard batteries (1.5 V/cell) and not rechargeable batteries (1.2 V) as the power supply of the
transmitter for operational safety and operating time reasons.
To insert the batteries, proceed as follows:
Remove the retaining screw (1) on the battery compart-
ment cover (2) on the back of the transmitter.
To open the battery compartment, press the two corrugat-
ed surfaces (3) and slide the battery compartment cover
upwards.
Insert 4 AA/Mignon batteries with correct polarity following
the instructions on the bottom of the battery compartment
(4). The spiral spring contact (5) must always be connect-
ed to the negative pole of the battery.
Lastly, close the battery compartment cover by sliding it
downwards and clicking it back into place in the transmit-
ter housing.
Re-tighten the retaining screws.
56
Figure 2