B) Attaching The Landing Legs; C) Attaching The Propeller Guard - Reely 1576770 Bedienungsanleitung

b) Attaching the landing legs

There are two bays (2) on the underside of the quadrocop-
ter for the two landing legs (1).
Plug the landing legs into the bays as shown in the adja-
cent photograph and secure each landing leg with one of
the included screws (3). Use the screwdriver included for
this purpose.

c) Attaching the propeller guard

Four plastic guards are included with the quadrocopter for
protection against the rotating propellers.
To attach to the guards, the plastic covers (1) must first be
removed from the retaining grooves (2).
Only now can you can the insert the propeller guard (3)
into the retaining groove. Apply gentle pressure so that the
protective guard clicks into place and is held securely.
Important note:
Even when the quadrocopter is shown without
the protective guard in these instructions for
illustrative purposes, you should always use
the quadrocopter with the propeller guards
mounted for safety reasons.
Figure 5
Figure 6
59