Gastroback 42720 Design Coffee Grind & Brew Advanced Pro Bedienungsanleitung Seite 83

Problem
The coffee is not hot.
Coffee brewer takes a long time to
brew.
Coffee brewer uses a lot of coffee.
The designated cup does not fit
under the drip stop outlet.
Possible Reason
The carafe or cups needs to be pre-
warmed.
The Grind Control™ System will
intelligently pre-heat and dose grinds
for optimum temperature and taste.
This may result in longer grinding,
pre-heating and brewing times than
what you are normally used to.
The Grind Control™ System has
been calibrated to dose the optimum
water to coffee grinds to achieve
the best flavour profile. Depending
on the selected STRENGTH setting,
this may result in more coffee being
ground than what you are normally
used to. However the result will be a
bolder, more full-flavoured coffee.
The maximum cup or travel mug
dimensions are 19 cm height, 14
cm in diameter.
The Solution
Just before brewing, pour some boi-
ling hot water into the carafe or cup
and leave for approx. 30 seconds.
Then discard the water and dry the
vessel.
If you wish your coffee quickly, it is
best to select the Single Cup mode.
If you would like to use less coffee
beans, select a lower STRENGTH
setting.
Remove the drip tray at the base of
the coffee brewer. Press the OPEN
button to open the swing-out door.
Insert the cup/mug into the drip tray
cavity. Close the swing-out door.
83