Gastroback 42720 Design Coffee Grind & Brew Advanced Pro Bedienungsanleitung Seite 74

the required size. There are 7 size options to accommodate for different amounts
or milk, half-and-half and creamer.
Note:
Always ensure your cup is an adequate size for the setting selected. The amounts
displayed on the LCD screen are approximate only. Actual amounts may vary
depending on the type of filter used, the coffee grind size, roast, blend and fresh-
ness, or amount and type of pre-ground coffee used.
5. Select the brew strength or 'PRE-GROUND' coffee setting
There are 8 strength settings. The LCD screen will display the current strength
setting. Rotate the STRENGTH dial to select your required strength. 1 is the
weakest and 8 is the strongest. We recommend starting on setting 4 for a medi-
um strength coffee. Adjust strength higher or lower to suit your taste.
Note:
If using pre-ground coffee, select the 'PRE-GROUND' coffee setting. This will dis-
able the grinder. Add pre-ground coffee to the gold tone filter or a paper filter.
We recommend 1 level tablespoon of pre-ground coffee per 150 ml cup of water.
Adjust the amount according to your individual taste. The maximum capacity for
pre-ground coffee is 12 level tablespoons. Exceeding this amount may cause over-
flow.
Note:
If using the grinder, ensure the filter is empty and in place. See: ›Before Each Use‹.
Do not overfill the bean hopper. The hopper lid must close without effort.
6. Start the brew cycle
Press the START | CANCEL button. The grinder will start grinding the correct
amount of coffee for the selected amount and strength. If the 'PRE-GROUND'
coffee setting has been selected, the grinder will be disabled.
Note:
Steam may emit from the rear steam vent during grinding and brewing. This is
normal.
Note:
If using the gold tone filter, you may notice that the brewing cycle finishes before
the ready signal sounds. This is normal. The total brewing time displayed on the
LCD screen is calculated using paper filters. Coffee passes through paper filters
slower.
7. The count-down timer will then begin. The time displayed is an estimate only and
will depend on the amount and strength settings you have selected. The LCD
screen will display:
74