John Bean B 300 Betriebsanleitung Seite 42

D
W
O
1
42
5-16
1 2
5-17
5-18
Operation
5.6.3 MANUAL data entry
Manual data entry is required in case of gauge arm
malfunctions. Proceed as follows:
5.6.3.1 Manual entering of the rim Width
Rim width can be entered via the menu keys, in this
case the rim diameter has to be determined manually.
If rim width is not given on the rim, it can be measured
on standard rims using the optional Rim Width Calliper
(Fig. 5-16).
— Access the function ENTERING RIM WIDTH
selecting the key W (Fig. 5-17).
— Press the key - or + (1, 2, Fig. 5-17) until the
required value is reached.
5.6.3.2 Manual entering of the Ofset
Position the gauge arm correctly
—
— Access the ENTERING RIM OFSET selecting the
key O (Fig. 5-17).
• Read the arm extraction value on the gauging rod.
• Enter the value read previously using the appropriate
keys - or + (1, 2, Fig.
5.6.3.3 Manual entering of the rim Diameter
Read the nominal rim diameter directly on the rim
•
or tyre itself.
• Select the DIAMETER; key
(Fig.
5-17).
• Enter the value read previously using the appropriate
keys - or + (1, 2, Fig.
• Select another measurement to edit (if necessary)
or spin the wheel.
...
(1, Fig. 5-18).
4-17).
on the control panel
D
5-17).