Inhaltsverzeichnis
Werbung
102
Trouble shooting
7.1.2
E-codes
When the E-code is displayed, a low beep is generated.
Whenever a code appears:
• note it down
• look up the code in the list. If the code is not de-
scribed, call service.
• perform the steps described.
The setup of this chapter is:
Code
Description
• Step(s) to be performed.
Some error messages are displayed for approx. 3
seconds on the display of the right side.
• To clear the error code immediately (e.g.: open the
wheel guard) or press the STOP key.
E 9 (
7.1.3)
F
E10
Gauge arm removed from idle position during wheel
spin.
• Bring gauge arm to the idle position (fully in and
down).
• Re-spin the wheel without touching the gauge arm.
• If the error appears again, have the gauge arm
calibrated (by the service department).
Display clears after several seconds.
E11
During ignition the gauge arm is not in the idle position.
• Move the gauge arm back carefully to the idle
position.
The error should disappear within a few seconds.
• If the error appears again, contact the service
department.
Note:
By pressing STOP you can continue to
use the machine but all the wheel data
must be inserted manually (
E 14 (
7.1.3)
F
E 21 (
7.1.3)
F
...
5.6.3).
F
Werbung
Inhaltsverzeichnis
