John Bean B 300 Betriebsanleitung Seite 20

1
4 5 6
20
2 3
7 8 9
4-6
Layout
4. + key
To increase an input value (e.g. rim diameter, offset,
10
rim width).
Hold down to change the value shown automatically.
5. Enter key
Press to confi rm input (dimension, mode) or save
"user" settings. The unit will beep.
6. - key
To decrease an input value (e.g. rim width, offset,
rim diameter).
Hold down to change the value shown automatically.
7. * key with indicator
Press to scroll along the special modes.
The * key indicator will light up, the unit will beep.
8. Fine key
Press to toggle the read-out accuracy between 5
and 1 grams (0,25 resp. 0,05 oz.). The unit will
beep.
Combined with the * key, it starts the calibration
function.
9. Weight key
Press to select the required weight application
mode (weight mode), the unit will beep.
Combined with the * key, it starts the "user" function.
Note: If pressed for at least three seconds, it recalls
directly the Normal mode (Clip-Clip) and reduces
the number of ALU modes that can be selected
"Quick ALU Mode" (
10.Stop key
Press to stop a spinning wheel.
Note:
The STOP key also has an instant stop function.
F
5.5).
...