Shutting Down - John Bean B 300 Betriebsanleitung

IMMEDIATE STOP
32
5-10
Operation

5.4.4 Shutting down

Always shut down properly when work is complete:
• Remove the and hub nut and the wheel from the
balancer.
• Remove the cones from the stub shaft. Check the
surfaces (internal and external) of the cones for
damage. The condition of the cone is very important
for a good balance quality.
• Store the cones and the hub nut in the correct place.
• Check the thread of the hub nut and stub shaft.
• Clean all threads and surfaces with a dry, soft cloth.
• Unplug the mains cable from the power outlet.
• Check the power cable for damage or wear.
• Tidy up the storage areas.
• Clean the display and input panel with a soft, dry cloth.
• Remove old wheel weights and other material from
under the balancer. The balancer must rest on its
three feet only.
5.4.5 Removal of the wheel
• Carefully untighten the quick release hub nut or the
mounting studs.
• Do not slide the rim on the threads, but lift the wheel
when removing it.
• Check the thread for damage and clean if necessary.
5.4.6 Immediate stop
See Figure 5-10.
To perform an immediate stop:
• Select the STOP key to apply the electronic brake.
• Apply the foot brake to stop the wheel.
When the immediate stop was made, due to an
unexpected action of the unit, rethink the steps
that were made:
Did the operator make an error or mistake?
Correct the input and proceed working. No
special procedure is to be followed.
Did the unit do something unexpected?
• Read the relevant chapters again.
• Prepare the unit for a restart: Switch on the unit.
• Carefully repeat the commands with the manual at hand.
• Call service immediately if the unit malfunctions
again and:
CAUTION: PREVENT ANY FURTHER USE OF
THE UNIT.
...