Sharp SD-AT100H Bedienungsanleitung Seite 288

Timer and sleep operation (continued)
SD-AT100H
ENGLISH
To check the timer setting:
1 Whilst in the timer playback stand-by mode,
press the TIMER button.
2 Within 10 seconds, press the
the ENT button.
The unit returns to the timer playback stand-by mode after the setting contents
are displayed in order.
When the start time is reached:
Playback starts automatically and the volume increases gradually.
The timer playback indicator flashes.
Timer playback indicator
When the finish time is reached:
The unit is set to the power stand-by mode automatically.
E-59
or button to select "TIMER CALL", and press
Timer setting indicator
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To reuse the same setting,
perform the following operations.
1 Turn the power on and press the TIMER button.
2 Within 10 seconds, press the ENT button.
After the setting contents are displayed in order, the unit is set to the timer play-
back stand-by mode.
Changing the timer setting:
Turn the power on, and repeat the operation from step 1 in "Setting the timer" (page
58).
Cancelling the timer playback:
Timer playback is cancelled by turning the power on whilst in the timer playback
stand-by mode. The same operation can be performed in the following procedure
without turning the power on.
1 Press the TIMER button.
"TIMER CANCEL" will appear.
2 Within 10 seconds, press the ENT button.
Timer playback will be cancelled (the contents of the setting will not be cancelled).
Caution:
z The contents of the setting will be erased if the unit is unplugged or a power failure
occurs. In such cases, set the timer again.
z This unit cannot set the timer of other equipment.
z When setting the timer playback using the digital tuner, TV, VCR, or the connected
equipment should be set to timer playback at the same time.
Note:
The timer operation is disabled with discs containing menus.
01/11/16 SD-AT100H(H)E6.fm