Setting The Clock - Sharp SD-AT100H Bedienungsanleitung

Setting the clock

By setting the unit on time, you can use it not only as a clock but also for timer play-
back.
[Back]
In this example, the clock is set for 9:30.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TIMER button.
3
Within 10 seconds, press the or
and then press the ENT button.
4
Press the or
and then press the ENT button.
Press the
vance continuously.
5
Press the
utes and then press the ENT button.
z Press the
z The hour will not advance even if minutes advance from "59" to "00".
z The clock starts from "0" second. (Seconds are not displayed.)
To confirm the time display:
[When the unit is in the stand-by mode]
Press the DISPLAY button on the remote control.
The time display will appear for about 5 seconds.
[When the power is on]
Press the TIMER button.
Within 10 seconds, press the
The time display will appear for about 10 seconds.
Caution:
Unplugging the unit or power failure will clear the clock setting.
Readjust the clock.
To readjust the clock:
Perform "Setting the clock" from the beginning.
z In step 2, "TIMER STANDBY" appears.
z In step 3, press the
ton.
button to select "ADJUST",
button to adjust the hour
or button once to advance the time by 1 hour. Hold it down to ad-
or button to adjust the min-
or button once to advance the time by 1 minute. Hold it down
to advance continuously.
or button to select "CLOCK".
or button to select "CLOCK", and the press the ENT but-
01/11/16 SD-AT100H(H)E3.fm
SD-AT100H
ENGLISH
E-24