Maintenance Intervals; Storage - Scheppach Pcs56E Originalbetriebsanleitung

1. Hold the file horizontally (at the correct angle to
the guide bar (16) and file according to the angle
marking on the file holder. Support the file holder
on the top plate and the depth limiter.
2. Always file the cutting link from the inside out.
3. The file only sharpens as it moves forward. Lift
the file off as you move backwards.
4. Do not touch the drive links or fastening links with
the file.

13.9 Maintenance intervals

The information given here refers to normal operating conditions. In difficult conditions, such as heavy dust generation
and longer daily working hours, the specified intervals should be shortened accordingly.
Device part Action
Chain lubrication Check
Saw chain (17) Check and
pay attention
to the state of
sharpness
Check chain
tension
Sharpen
Guide rail (16) Check (wear,
damage)
Clean
Replace
13.10 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Saw chain, guide rail, chain wheel,
chain oil, engine oil, claw stop, chain catcher, spark
plug, air filter, fuel filter, chain oil filter
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from
our Service Centre. To do this, scan the QR code on
the front page.
m Warning!
Only use original spare parts and accessories from
the manufacturer. Failure to do so can reduce perfor-
mance, result in injuries and void your warranty.
Important note in the case of repairs:
When returning the device for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is
sent to the service centre.
Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Device type
5. Turn the file regularly to avoid wear on one side.
6. Use a piece of hard wood to remove the burr from
All cutting links must have the same length, otherwise
they will also be of different heights.
This causes the saw chain (17) to run erratically and
increases the danger of breaking.
Before
Weekly
starting work
X
X
X
X
X
• Device article number
Approved cutting gear
Only approved spare parts, such as those named in
this operating manual, may be used. To do this, con-
tact our customer service.
20" saw chain
Kangxin 325.058-76 ............................... 7910100723
Oregon 21BPX078X ............................... 7910100717
20" guide bar
Kangxin BE20-76-5812P ....................... 7910100724
Oregon 208PXBK095(546876) .............. 7910100718

14. Storage

• Always use the guide rail cover (27) when storing.
• Clean and maintain the device every time before
• Store the device in a safe, dry, frost-free, well-ven-
• Empty the oil or fuel tank with a suction pump.
www.scheppach.com
cutting edges.
In the event of In the event of
malfunctions damage
X
X
storage (see chapter "Cleaning and maintenance").
tilated place protected from the weather. Outdoor
storage is not advisable. Also secure it from unau-
thorised access.
If necessary
X
X
GB | 45