Transferring Measurements - Beurer BM 85 Gebrauchsanweisung

• When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
• When the relevant memory button (M1 or M2) is
pressed again, you can view your individual measure-
ments.
• To switch the device off again, press the START/STOP
button .
You can exit the menu at any time by pressing the
START/STOP button
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start individual measurement access.
• Press and hold the M1/M2 memory buttons for 5 sec-
onds.
All the values in the current user memory are
deleted.
It is not possible to delete individual
measurements.
.

8. Transferring measurements

Transfers using the USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
PC is shown on the display.
Begin the data transfer in the "HealthManager" PC
software. During the data transfer, an animation is
shown on the display. A successful data transfer is
displayed as in figure 1. If the data transfer is
unsuccessful, an error message appears as in
figure 2. In this case, interrupt the PC connection
and start the data transfer again.
After 30 seconds of not being in use or if communi-
cation with the PC is interrupted, the blood pressu-
re monitor switches itself off automatically.
Bluetooth Smart transfers
®
It is also possible to transfer the measured values saved on the
device to your smartphone using Bluetooth
You will need the Beurer "HealthManager" app for this. The
app is available from the app store.
Proceed as follows to transfer values:
data is transferred if Bluetooth
tings menu. The symbol appears in the top left of the display
(see section 4 "Preparing for the measurement").
31
fig. 1
fig. 2
Smart.
®
has been activated in the set-
®