Transferring Measurements - Beurer BC 85 Gebrauchsanweisung

7. Transferring measurements

Transfers using the USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
PC is shown on the display. Begin the data
transfer in the "HealthManager" PC software.
During the data transfer, an animation is
shown on the display. A successful data trans-
fer is displayed as in fi gure 1. If the data trans-
fer is unsuccessful, an error message appears
as in fi gure 2. In this case, interrupt the PC
connection and start the data transfer again.
After 30 seconds of not being in use or if
communication with the PC is interrupted,
the blood pressure monitor switches itself off
automatically.
®
Transfer via Bluetooth
It is also possible to transfer the measured values saved on
the device to your smartphone using Bluetooth
You will need the Beurer "HealthManager" app for this. The
app is available from the App Store.
Proceed as follows to transfer values:
®
If Bluetooth is activated in the settings menu, the data is
transferred automatically after the measurement. The
bol appears in the top left of the display (see chapter 4 "Pre-
paring the measurement").
figure 1
Step 4:
data transfer immediately
figure 2
following measurements.
• If Bluetooth
fer has been activated,
data is transferred after
®
.
having confirmed the user
memory and pressing the
START/STOP button
The Beurer "HealthManager" app must be active to allow
sym- data transfers.
27
Step 1: BC 85
®
Activate Bluetooth on your device (see chapter
4 "Preparing the measurement, Bluetooth
Step 2: Beurer "HealthManager" app
In the Beurer "HealthManager" app, add the
BC 85 under "Settings/My devices".
Step 3: BC 85
take a measurement.
BC 85: Step 4:
Data transfer at a later point:
• Go to memory mode
®
data trans- (chapter 7). Select the
desired user memory. The
Bluetooth
automatically.
.
®
").
BC 85:
®
transfer starts