Transferring Measurements - Beurer BM 77 Gebrauchsanweisung

8. Transferring measurements

USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst
performing a measurement.
PC is shown on the display. Begin the data transfer
in the "HealthManager" PC software. During the
data transfer, an animation is shown on the display.
A successful data transfer is displayed as in
figure 1. If the data transfer is unsuccessful, an
error message appears as in figure 2. In this case,
interrupt the PC connection and start the data
transfer again.
After 30 seconds of not being in use or if com-
munication with the PC is interrupted, the blood
pressure monitor switches itself off automatically.
Transfer via Bluetooth
®
It is also possible to transfer the measured values saved on the
device to your smartphone using Bluetooth
You will need the Beurer "HealthManager" app for this. Install
the „Beurer HealthManager" from the Apple App Store or Goo-
gle Play. Proceed as follows to transfer values:
If Bluetooth is activated in the settings menu, the data is
®
transferred automatically after the measurement. The
appears in the top left of the display (see chapter 4 "Preparing
the measurement").
figure 1
figure 2
Step 4
data transfer immediately
following measurements.
• If Bluetooth
.
®
symbol
If your smartphone has a protective cover, remove this to ensu-
re that there is no interference during the transfer. Begin the
data transfer in the Beurer "HealthManager" app.
33
Step 1: BM 77
Activate Bluetooth
4 "Preparing the measurement, Bluetooth
Step 2: Beurer "HealthManager" app
In the Beurer "HealthManager" app, add the
BM 77 under "Settings/My devices".
Step 3: BM 77
take a measurement.
BM 77:
data trans-
®
fer has been activated,
data is transferred after
having confirmed the user
memory and pressing the
START/STOP button .
The Beurer "HealthManager" app must be active to allow
data transfers.
on your device (see chapter
®
").
®
Step 4 BM 77:
Data transfer at a later point:
• Go to memory mode
(chapter 7). Select the
desired user memory. The
Bluetooth transfer starts
®
automatically.