Preparing For The Measurement - Beurer BM 85 Gebrauchsanweisung

4. Preparing for the measurement

Completely charge up the blood pressure monitor before ta-
king your first measurement:
• Using a PC:
Insert the USB cable into the USB interface on the device
and directly connect it to your PC.
• Using the mains part
Insert the USB cable into the blood pressure monitor and
connect it to mains supply using the enclosed USB mains
part.
The symbol is shown once the device is fully charged.
Charge the battery if the battery level symbol flashes. If the
device's battery has been completely drained and you are
unable to switch it on again, you must reset the date, time and
Bluetooth settings. In this process, any saved measurements
®
are retained.
Set the hour format, date, time and Bluetooth
The following section describes the functions and settings
available on the blood pressure monitor.
Hour format Date
➔
It is essential to set the correct date and time. Otherwise, you
will not be able to save your measured values correctly with a
date and time and access them again later.
If you press and hold the M1 or M2 memory button, you
can set the values more quickly.
Press and hold the START/STOP button
® settings
Bluetooth
Time
➔ ➔
settings
for 5 seconds.
The hour format now flashes on the display.
• Select the desired hour format using the
M1/M2 memory buttons and confirm with
the START/STOP button
The year flashes on the display.
• Select the year using the M1/M2 memory
buttons and confirm with the START/
STOP button
The month flashes on the display.
• Select the month using the M1/M2 mem-
ory buttons and confirm with the START/
STOP button
The day flashes on the display.
• Select the current day using the M1/M2
memory buttons and confirm with the
START/STOP button
If you have set the 12h hour format, the month is
displayed before the day.
®
The hours flash on the display.
• Select the current hours using the M1/
M2 memory buttons and confirm with the
START/STOP button
The minutes flash on the display.
• Choose the current minutes using the M1/
M2 memory buttons and confirm with the
START/STOP button
24
.
.
.
.
.
.