Cleaning And Storing The Unit; Error Messages/Troubleshooting - Beurer BM 85 Gebrauchsanweisung

Step 1: BM 85
activate Bluetooth
4 "Preparing for the measurement, Blue-
tooth ").
®
Step 2: Beurer "HealthManager" app
In the Beurer "HealthManager" app, add the
BM 85 under "Settings/My devices".
Step 3: BM 85
take a measurement.
Step 4: BM 85
data transfer immediately
following measurements.
• Select the desired user
memory. Start Bluetooth
data transfer (chapter 5)
on your device (see section
®
Step 4: BM 85
Data transfer at a later point:
• go to memory mode
(chapter 7). Select the
desired user memory.
®
Bluetooth data transfer
®
starts automatically.
The Beurer "HealthManager" app must be active to allow
data transfers.
If your smartphone has a protective cover, remove this to ensu-
re that there is no interference during the transfer. Begin the
data transfer in the Beurer "HealthManager" app.

9. Cleaning and storing the unit

• Clean the unit and cuff carefully using a slightly damp cloth
only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under wa-
ter, as this can cause liquid to enter and damage the unit.
• If you store the unit, no heavy objects should be placed on
top of it. Remove the batteries. The cuff line should not be
bent sharply.

10. Error messages/troubleshooting

Error messages may appear if:
• the blood pressure values are unusually high or low (
pears on the display)
• you move or speak during the measurement (
the display)
• the cuff line has not been inserted properly (
the display)
• inflation takes longer than 15 seconds (
display)
• the pump pressure is higher than 300 mmHg (
the display)
32
ap-
appears on
appears on
appears on the
appears on