Atag HI86471FV Gebrauchsanweisung Seite 223

Power limiter
See chapter 'Settings', under Con - power limiter to set the parameter. This parameter must be set
before placing a pan on the hob or activating a cooking zone.
WARNING!
Setting the power limiter should only be carried out by a registered and qualified installer.
Please read the safety regulations and the installation instructions carefully.
Some automatic cooking functions are disabled if the appliance power limiter is set to a lower
value. Refer to the table below.
Phase IMax (A)
3 Phases 16
13
10
6
2 Phases 16
(2 and 3
13
interconnected)
10
6
1. Open the cover of the connection terminal box.
2. Run the power cord through a cord strain relief (clamp) which
protects the cable from being pulled out.
3. Connect the wires according to your type of appliance.
4. Make the necessary connections between the terminals using the
supplied terminal bridges (TB). The terminal bridges are located in
the connection box.
Grilling Frying
x x
x x
- -
- -
x x
x x
- -
- -
Boiling Simmer
x x
- x
- x
- x
x x
- x
- x
- x
Installation
Keep warm Melting
x x
x x
x x
x x
x x
x x
x x
x x
47