Atag HI86471FV Gebrauchsanweisung Seite 213

Table continued from last page
Symptom
Zone stops unintended and
residual heat indicator is shown.
A fuse blows when the hob is
connected to the electrical
power mains.
The ceramic glass plate broke.
Error codes
Symptom
Error codes F0 to F7 and FC.
Error codes Fc
Error code FC02
Error codes Fc01, FC04,
FC08 , FC10 and FH
Error codes FJ
Error codes F9
Other error codes.
NOTE!
In case of other error codes: please write down the error code and contact the service department.
Possible cause
Zone is overheated.
The appliance is incorrectly
connected.
Possible cause
Defective generator.
Appliance overheated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Control panel error
Mains voltage is too low.
Air circulation not good.
Troubleshooting
Solution
After the hob has cooled down,
cooking can be continued.
Check the electrical
connections.
Disconnect the device from the
power supply. Contact your
installer.
Please note! Do not throw a
broken ceramic glass plate in
the glass recycling bin but take
this to the Municipality's waste
recycling centre.
Solution
Disconnect the device from the mains,
wait 10 seconds and reconnect.
Contact the technician if the error code
does not disappear.
Let the appliance cool down and start
cooking again.
Have your connection changed.
Disconnect the device from the mains,
wait 10 seconds and reconnect.
Contact the technician if the error code
does not disappear.
Contact your energy supplier.
Make sure the venting holes under the
cooking plate are open.
Contact the service department.
37