Atag HI86471FV Gebrauchsanweisung Seite 207

The following settings are available (depending on the model).
boo - Auto boost
Automatic Boost
activation
brd - Auto bridge
Automatic coupling
SEL - Auto Select
Auto select
dES - Auto deselect
Auto deselect
dYn - Dynamic Slide
Dynamic Slide
rEC – Move and
recover function
Move and recovery
function
dEt - Pan Detection
Time-out
Pan detection time-out
AtI
–'Auto-Stopwatch-timer'
Automatic
Stopwatch-timer
Cdn - Timer Countdown
Countdown timer start
If enabled, the boost level is activated automatically when level 12 is
switched on. If off, boost is activated by selecting power level 12 and then
long-selecting level 12 again.
While on, when a new pan is detected on two connected Bridge Induction
cooking zones, the cooking zones are automatically connected into one
big cooking zone. While off, connecting must be done manually by
pressing on the sliders of two Bridge Induction cooking zones at the same
time.
You can choose whether (on) or not (off) the slider will automatically appear
when the first pan is placed on the hob.
on
off
Choose whether (on) or not (off) automatic closing of the slider after 6 sec
of not being used. When 'DES' is set to 'off', the slider must be closed
manually.
on
off
Choose to use (on) or not (off) the dynamic slider. If 'dYn' is off, the slider
always appears in the middle.
on
off
While on, the recovery function is active and, settings can be moved from
one cooking zone to the other when a pan switches position.
Set the time for how long the hob should detect if a pan is placed on the
cooking zone.
0.01 (standaard) = 1 min
0.10 = 10 min
If 'Auto-Stopwatch Timer' is on, the stopwatch timer will start counting
immediately when a power level is set. The current value will not be
visible until the stopwatch timer is selected.
If 'Auto-Stopwatch Timer' is off, the stopwatch timer will start counting
after selecting it.
Set the time when the timer should start counting down:
Off (timer does not count down)
0.20 (20 seconds before end of set time)
1.00 (60 and 20 seconds before end of set time)
Settings
31