Electrical Connection - Atag Hi86471Fv Gebrauchsanweisung

Installation
Sealing tape

Electrical connection

Determining the existing electrical connection
Check the voltage. Before connecting the appliance, make sure the voltage specified on the
rating plate conforms to the voltage of your power mains. The voltage of your power mains
(220–240 V between L and N) should be checked by an expert using an appropriate measuring
device.
Check the voltages present as indicated in the diagrams below.
3 phases - 1 neutral
2 phases - 2 neutral (only for NL)*
*The 2 phases (L1 and L2) should be secured by only one and the same earth leakage breaker.
Running L1/N1 through a different earth leakage breaker than L2/N2 is not allowed.
Connection diagram
NOTE!
Consult the wiring diagrams on the bottom of the appliance.
46
Hob
Sealing tape (S)
2 phases - 1 neutral
3 phases (only for BE)
1 phase - 1 neutral
1 phase (only for BE)