Atag HI86471FV Gebrauchsanweisung Seite 209

Table continued from last page
The following settings are available (depending on the model).
Con - Connection
power
Current limiter
(connection to power
grid)
dE - Demo mode
Demo Mode for Dealer
Showrooms
WARNING!
A registered and qualified installer must set the current limiter to match
your connection and circuit breakers. Please read the safety regulations
and the installation instructions carefully.
If your electrical wiring or circuit breakers do not meet the specified current
draw on the rating plate, the current limiter can be activated by reducing
the value of this setting. Doing so will cause a reduced performance of
the induction hob.
The number left of the dot represents the number of connected phases,
while the number right of the dot represents the electrical current per
phase in Ampere.
WARNING!
The appliance must always be set to the actual or lower rating of the
electrical wiring or circuit breakers. This setting can only be set by an
authorised expert.
NOTE!
To prevent unintentional adjustment of the 'Con - connected power',
Con setting must be confirmed when changed by touching the cooking
zone key for 3 seconds. A change without confirmation will not be
implemented!
3 sec.
In demo mode, the appliance will act as usual, without the possibility to
heat the cookware.
When demo mode is active, this is briefly indicated by 'dE' after the device
is switched on.
Without any user interaction, the appliance will automatically switch off
after 10 minutes.
Settings
3 sec.
33