Cooking With The Plus Menu - Atag Hi86471Fv Gebrauchsanweisung

3. Use the slider of the front cooking zone to set the desired cooking setting for the linked cooking
zones.
4. Touch both cooking zone keys again to unlink the cooking zones.

Cooking with the PLUS menu

The PLUS menu allows cooking with semi-automatic programs, enabling temperature cooking for
all kinds of cookware that fit the program's purpose.
The automatic cooking programs, up to 100-degree program, operate based on temperature
measurements, which means heating times may vary depending on the amount in your pan. For
optimal performance, choose a cooking zone equal to or slightly smaller than the diameter of your
pan base. The following quantities per pan base diameter are recommended for the best performance:
160 mm (1 litre), 200 mm (2 litres), and 240 mm (3 litres). You can also use other quantities, but
remember that this may affect performance.
1. Touch the PLUS programs key to select the program: keeping warm/heating up and grill.
2. Use the slider to select a plus program temperature (see table).
Heating up/keeping warm indicator lights up.
At a selected temperature above 100 °C, the 'frying' indication comes on.
When the program or temperature selection does not change for 3 seconds, the program is activated.
To deactivate a PLUS program, press the active cooking zone key for about three seconds or select
a power level manually.
For certain programmes, such as Heating up/keeping warm and Frying, confirmation is required
after the heating phase ends and the food has been added. When the set temperature and the PLUS
programme icon are flashing and an audible signal sounds, add the food to the pan. Then confirm
by pressing the temperature indicator within 2 minutes. From that point on, the programme will
maintain a constant temperature.
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds the
maximum available amount of power, the power is automatically reduced. The display of the cooking
zone who is being reduced in its power is first flashing; the level is then automatically reduced to
the highest available power.
NOTE!
Always add water, a little oil or butter before starting a programme; never use an empty pan or
pot.
Operation
21