RCB RK29 Originalbetriebsanleitung Seite 56

4. Fasten the top cover screw plug.
7
1
3
4
2
2. Front mudguard installation
1. Remove the screws on the front fork beam
using an M5 hexagon socket, then align the
mud plate lifting lugs with the screw holes and
tighten the screws.
2. Remove the screws on the front fork legs,
and then align the mud plate support holes with
the access holes.
3. Finally, use an M5 hex wrench to tighten the
screws.
German /
4
6
8
English / French / Spanish / ltalian / Dutch / Poland / Czech
5. Use the No. 4 Allen wrench in the
16-in-1 tool to remove the 4 front cover
screws and remove the riser front cover.
7. Use the No. 4 Allen wrench in the
16-in-1 tool to gradually tighten the 4 front
cover screws in the order shown in the
picture.
8. Use the No. 3 Allen wrench in the
16-in-1 tool to loosen the screws on both
sides of the display, and the display can
easily rotate to the appropriate position
and angle. Tighten the screws again.
(54)
5
6. Place the handlebar
into the riser and adjust
the handlebar angle in
the center.
Fasten the front cover.
Note: Do not twist the
wiring harness.