Device Operation - Nice Doubledimmer-Control Anweisungen Und Warnhinweise Zu Installation Und Gebrauch

5
ADDING DEVICE TO Z-WAVE NETWORK
If you encounter problems adding, removing, or using the wall switches connected to terminals S1 or S2, use the PROG button located on the
device housing.
The device tries to add itself after pressing the switch 3 times.
Adding (Inclusion) - The Z-Wave device learning mode enables adding the device to the existing Z-Wave network.
5.1 - Adding the device to the Z-Wave network manually
1. Place DoubleDimmer-Control within the direct range of your Z-Wave hub.
1. Set the main hub to add mode (secure or non-secure). For more information, see the hub manual.
2. Quickly press the S1 or S2 switch, or the PROG button, three times.
3. If you're adding the device in the Security S2 Authenticated mode, input the PIN Code labelled on the device. The PIN Code is also an un-
derlined part of the device specific key (DSK) labelled at the bottom of the box.
4. Wait for the adding process to finish.
5. Successful adding is confirmed by the Z-Wave hub message and the device LED indicator:
Green – successful (non-secure, S0, S2 non-authenticated mode)
Magenta – successful (Security S2 Authenticated mode)
Red – not successful
5.2 - Adding using SmartStart
SmartStart solution enables products to be added into the Z-Wave network by scanning the Z-Wave QR Code present on the product with a hub
providing SmartStart inclusion. A SmartStart product is added automatically within 10 minutes of being switched on in the network range.
Note
To use the SmartStart solution, your hub needs to support Security S2 mode. For more information, see the hub manual.
To add the device to the Z-Wave network using SmartStart:
1. Enter the full DSK string into your hub. If your hub supports QR scanning, scan the QR code on the label.
2. Power the device by switching on the mains voltage.
3. The LED indicator starts blinking yellow – wait for the adding process to finish.
4. Successful adding is confirmed by the Z-Wave hub message and the device LED indicator:
Green – successful (non-secure, S0, S2 non-authenticated mode)
Magenta – successful (Security S2 Authenticated mode)
Red – not successful
Note
In case of problems with adding the device, reset the device and repeat the adding procedure.
6

DEVICE OPERATION

6.1 - Controlling DoubleDimmer-Control with PROG-button
DoubleDimmer-Control is equipped with the PROG-button, which enables using the menu and performing actions listed in the table below.
Table 2 - DoubleDimmer-Control - PROG-button actions
Action Result
1x click • Select a desired menu position (if the menu is active)
• Turn on/off both channels (the 1
3x click Send the Node Info Z-Wave command frame (adding/removing)
Hold Enter the menu
6.2 - Resetting DoubleDimmer-Control
1. Switch off the mains voltage (disable the fuse).
2. Remove DoubleDimmer-Control from the wall switch box.
3. Switch on the mains voltage.
4. Press and hold the PROG-button to enter the menu.
5. Wait for the visual LED indicator to glow yellow (Position 1).
6. Quickly release and click the PROG-button again.
7. After a few seconds, the device restarts, which is indicated by the red LED indicator.
6
and 2 )
st nd