Lavorwash RIO-R Bedienungsanleitung Seite 25

pressure cleaner is intended to be used for domestic
and hobby work: the warranty does not cover any
other different kind of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with the
EU Directive 2012/19/EU on waste from
electrical and electronic equipment and the
national laws of the EU Member States that have
implemented this Directive) prohibits you from
disposing of this product or its electrical / electronic
accessories as municipal solid waste and obliges
you to make use of the appropriate waste collection
facilities.The product can be disposed of by
returning it to the distributor when a new product is
purchased. The new product must be equivalent to
that being disposed of. Disposing of the product in
the environment can cause great harm to the
environment itself and human health. The symbol
in the figure indicates the urban waste containers
and it is strictly prohibited to dispose of the
TROUBLESHOOTING
FAULT PROBABLE CAUSE
1. The pump does 1. The plug is not properly connected to the
not start when the socket.
switch is 2. The electrical socket is not working.
pressed. 3. The mains voltage is insufficient.
4. The gauge of the electrical power lead is too
small.
5. The pump has cut out.
2. The machine starts, 6. Pump, hoses or accessories frozen.
but no water comes 7. No water supply.
out.
8. Water filter fouled.
9. Nozzle fouled.
3. The pump runs but 10. Insufficient water.
pressurisation does 11. Suction filter fouled.
not 12. Pressure regulator valve (if fitted) on mini-
take place. mum pressure setting.
13. Lance nozzle worn.
14. Suction or delivery valves fouled or worn.
equipment in these containers. Non-compliance
with the regulations stipulated in the Directive
2012/19/EU and the decrees implemented in the
various EU Member States is administratively
punishable.
REPAIR
1. Connect the plug to the power socket
correctly.
2. Have the electrical socket checked.
3. Check that the system is suitable.
4. Refer to the section detailing the electrical
connection.
5. Turn the switch to ON while keeping the gun
lever pressed; if the problem persists contact an
authorised service centre.
6. Allow the pump and hoses to thaw.
7. Connect the machine to the water supply
system and turn on the tap.
8. Remove and clean the filter (see "MAINTE-
NANCE" section).
9. Remove the lance from the gun and clean the
nozzle with the pin provided.
10. Check that the delivery rate is at least 12 l/
min.
11. Remove and clean the filter (see "MAINTE-
NANCE" section).
12. Increase the pressure by turning the
handgrip.
13. Replace the lance.
14. Contact an authorised service centre.
EN
25