Put Into Service / Starting Up - Lavorwash Rio-R Bedienungsanleitung

Please read the instructions given below before
connecting the cord to a plug. If in doubt please
consult a qualified electrician. As the colours of the
wires in the mains lead of this appliance may not
correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wires that is coloured Brown must be connected
to the terminal which is marked with the letter L or
coloured Red. The wire that is coloured Blue must be
connected to the terminal which is marked with the
letter N or coloured Black.
Safety points for rewireable or moulded plug:
The mains lead of this appliance may be already fit-
ted with a BS1363 13A plug.
- If your socket outlet is not suitable for the plug,
then the plug must be removed (cut off if it is a
moulded on plug), the flexible cord insulation
should be stripped back as appropriate and a
suitable 3 pin plug fitted.
WARNING:
•
been cut from the power supply cord, as such a
plug is hazardous if inserted in a live 13A socket
outlet elsewhere in the house.
- Should the fuse need to be replaced an ASTA
marked fuse, approved to BS1362, of the same
rating must be used.
- Always replace the fuse cover after fitting a fuse.
Dispose of a plug that has
The plug must NOT be used if the cover is omitted
or lost until a replacement is obtained.
- Make certain that only the correct fuse cover is
used and fitted.
- For plugs with detachable fuse cover the replace-
ment must be the same as the colour insert in the
base of the plug, or as directed by the embossed
wording on the base of the plug.
- If the detachable fuse cover is lost a replacement
may be purchased from a Service Centre.
PUT INTO SERVICE / STARTING
UP
See fig. A
- Connect the high pressure hose to the trigger
gun.
- Push the high pressure hose into the trigger gun.
NOTE:
Make sure the connection nipple is
aligned correctly.
- Check the secure connection by pulling on the
high pressure hose.
See fig. B
- Insert the high pressure hose tightly into the
quick coupling on the appliance
See fig. C
- Screw the coupling element to the water connec-
tion on the appliance.
- Attach the water supply hose to the coupling on
the water connection.
NOTE:
The supply hose is not included.
- Connect the water supply hose to the water sup-
ply.
- Completely open the water tap.
- Insert the mains plug into the socket.
- Turn on the appliance "I/ON".
See fig. D
- Unlock the lever on the trigger gun.
- Pull on the lever of the trigger gun; the device will
switch on.
- Switch the appliance on for a (max. of 1 minute)
and wait until the water exits at the hand spray
gun without bubbles.
- Release the lever on the trigger gun.
NOTE:
Release the lever of the trigger gun; the
device will switch off again.
- High pressure remains in the system.
See fig. E
EN
21