Safety Device - Lavorwash Rio-R Bedienungsanleitung

maintenance and when replacing parts or when
converting the machine to another function.
WARNING:
26
• Inadequate extension cords
can be dangerous. If an extension cord is used,
it shall be suitable for outdoor use, and the
connection has to be kept dry and off the ground.
It is recommended that this is accomplished by
means of a cord reel which keeps the socket at
least 60 mm above the ground
79:2021)
WARNING:
27
• If an extension cord is used,
the plug and socket must be of watertight
construction.
WARNING:
28
• During use of high pressure
cleaners, aerosols may be formed. Inhalation of
aerosols can be hazardous to health (IEC 60335-
2-79:2021)
WARNING:
29
•
Depending on the application,
shielded nozzles can be used for high pressure
cleaning, which will reduce the emission of
hydrous aerosols dramatically. However, not
all applications allow the use of such a device.
If shielded nozzles are not applicable for the
protection against aerosols, a respiratory mask
of class FFP 2 or equivalent may be needed,
depending on the cleaning environment (IEC
60335-2-79:2021) .
WARNING:
32
• It is absolutely forbidden
to use the machine in potentially explosive
environments or areas.
WARNING:
33
• When the unit is working do not
use it in a closed place where ventilation may be
insufficient and never cover the unit.
WARNING:
34
• By no means use the machine
during thunderstorms or when it is raining.
WARNING:
35
• Do not use the unit on
inflammables surfaces.
WARNING:
00
•
- NEVER EVER TOUCH THE MACHINE WITH WET
HANDS OR BARE FEET.
- NEVER PULL THE POWER SUPPLY CABLE OR
MACHINE IN ORDER TO DISCONNECT THE PLUG
FROM THE SOCKET.
- IF DURING FUNCTIONING THE POWER SUPPLY
RUNS OUT, FOR SAFETY REASONS, TURN THE
MACHINE OFF.
> SAFETY DEVICE
WARNING:
•
safety catch. Whenever use of the machine is
interrupted it is important to operate the safety
catch to prevent accidental activation of the jet.
- Safety features: gun equipped with safety
locking device, appliance equipped with (Class
I) overload cutout, pump equipped with by-pass
(IEC 60335-2-
valve or shutdown device.
- The safety button on the gun is not there to lock
the lever during operation, but to prevent its
accidental operation.
WARNING:
•
a motor protection device: in case of device
intervention, wait some minutes or, in alternative,
disconnect and re-connect the product to the
electric system. In case this problem repeats
again or if the product does not start again, take
the product to the nearest After Sales Service
Point
> STABILITY
WARNING:
•
kept on horizontal bases, in a safe and stable way.
USAGE
> DESCRIPTION OF THE MACHINE
See pag.4-5-6-7-8.
> ASSEMBLY INSTRUCTIONS
See pag.2-3.
> PUT INTO SERVICE
See fig.
- Check that the master switch is turned to "OFF"
and that the water filter is fitted into the pump's
inlet pipe.
- Screw the snap connection into place by hand,
without the aid of tools.
- Connect the water supply hose to the snap
connection. The hose must have an inside
diameter of at least 13 mm (1/2").
- Connect the high pressure hose to the pump's
outlet pipe. Press the high pressure hose coupling
fully down and then screw into place by hand
the gun is fitted with a
The appliance is equipped with
The machine must be always
EN
21