Switching Off - Lavorwash Rio-R Bedienungsanleitung

EN
or lost until a replacement is obtained. - Make
certain that only the correct fuse cover is used
and fitted. - For plugs with detachable fuse cover
the replacement must be the same as the colour
insert in the base of the plug, or as directed by
the embossed wording on the base of the plug. -
If the detachable fuse cover is lost a replacement
may be purchased from a Service Centre.
T.S.
( IF FITTED)
NOTE: (Automatic Stop System), which stops
the machine during the bypass phase. To start
the water cleaner, it is therefore necessary to set
the switch on position (I)"ON"; after that press
the pistol trigger: the Automatic Stop System will
start the machine and will stop it automatically
when the trigger is released. It is advisable to
put on the safety of the pistol trigger whenever
the machine is stopped, in order to avoid
unintentional starting.
- Any automatic start of the machine without
pressing the gun trigger is attributable to air
bubbles in the water or other similar phenomena
which do not imply the existence of any defects
in the machine.
- Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the (0) OFF position.
- Please check that the coupling of the high
pressure hose with the appliance and the gun
supplied as standard equipments made correctly,
that is to say without any water leak.
> SWITCHING OFF
See fig.
turn the switch pos. 2 (0) OFF position and wait that
the water get completly cold.
In this way you avoid any calcareous deposit and
overheatings of the coil and the boiler, which are
always dangerous.
IMPORTANT: When the machine is switched off,
always discharge the pressure hose, opening the
gun.
CARE AND MAINTENANCE
See fig.
24
WARNING:
25
•
disconnected from its power source, by removing
the plug from the socket-outlet, during cleaning
or maintenance
WARNING:
•
Do not spray the appliance with
water and do not use detergents or aggressive
solvents. Machine could be damaged.
- Clean the exterior part of the machine with a dry
cloth.
- Always keep the machine clean so that the
cooling air can pass through the slits without
obstructions..
- Cleaning the water filter: To ensure the pump
gives good service it is extremely important to
check and clean the water filter frequently. Use
pliers to extract it from the pump and rinse it
carefully in running water.
- Cleaning the nozzle: A blockage in the nozzle may
prevent the machine from operating correctly, so
it must be kept clean. Switch off the machine and
remove the lance. Clean the nozzle with the pin
provided. Rinse the lance in running water.
- When topping up the oil in the pump, use a SAE
20W40 mineral oil. Quantity supplied: 70 gr.
- The replacement of the fuel metal pipe is
requested after disassembling to avoid fuel
leakages.
> STORAGE
See fig.
- Move the machine only by grasping the carrying
handle
- Store the appliance and the accessories in a frost-
safe room.
WARRANTY CONDITIONS
All our machines are subjected to strict tests
and are covered against manufacturing defects
in accordance with applicable regulations. The
warranty is effective from the date of purchase. The
following are not included in the warranty: - Parts
subject to normal wear. - Rubber parts, charcoal,
filters and the accessories and optional accessories.
- Accidental damage, caused by transport, neglect
or inadequate treatment, incorrect or improper use
and installation failing - The warranty shall not cover
any cleaning operations to which the operative
components may be subjected, such as clogged
nozzles and filter blocked due to limestones. This
the machine shall be