Care And Maintenance - Lavorwash Rio-R Bedienungsanleitung

EN
- Lock the lever on the trigger gun.
> OPERATION
See fig. F
- Push the spray lance into the trigger gun and fas-
ten it by turning it through 90°.
See fig. G
- Unlock the lever on the trigger gun.
- Pull on the lever of the trigger gun; the device will
switch on.
WARNING:
•14
pressure. Keep a firm hold on the gun and be pre-
pared to take the kickback pressure.
> HIGH PRESSURE LANCE
See fig.H
It present (see packaging).
> ACCESSOIRES
See fig.IJ
It present (see packaging).
> DETERGENT SUCTION
See fig.KLMN
WARNING:
•04
signed for use with the detergent provided or the
detergent specified by the manufacturer, such as
a neutral shampoo based on biodegradable ani-
onic surface active detergents. The use of other
detergents or chemicals may put the appliance's
safety at risk.
> HIGH PRESSURE HOSE
See fig.O
Use the hydrocleaner only if the hose is completely
uncoiled and extended.
> SWITCHING OFF
See fig. P
22
Appliance with fluid under
This appliance has been de-
> T.S. TOTAL STOP
(if fitted)
NOTE:
Total Stop, which stops the machine
during the bypass phase. To start the water clean-
er, it is therefore necessary to set the switch on
position „I/ON"; after that press the pistol trigger:
the Total Stop will start the machine and will stop
it automatically when the trigger is released. It is
advisable to put on the safety of the pistol trig-
ger whenever the machine is stopped, in order to
avoid unintentional starting.
- Any automatic start of the machine without
pressing the gun trigger is attributable to air
bubbles in the water or other similar phenomena
which do not imply the existence of any defects
in the machine.
- Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the (0) OFF position.
- Please check that the coupling of the high pres-
sure hose with the appliance and the gun sup-
plied as standard equipment made correctly, that
is to say without any water leak.

CARE AND MAINTENANCE

See fig. Q
The unit is maintenance-free.
WARNING:
•25
nected from its power source, by removing the
plug from the socket-outlet, during cleaning or
maintenance
WARNING:
•
with water and do not use detergents or aggres-
sive solvents. Machine could be damaged.
- Clean the exterior part of the machine with a dry
cloth.
Fig. 1 Filter cleaning. Inspect the inlet filter before
each use, and clean it according to the instruc-
tions.
Fig. 2 Clean the two ends of the hose.
Fig. 3 Nozzle cleaning:
1) Disconnect the nozzle from the lance.
2) Use the specially provided pin to remove any de-
posits from the nozzle hole.
Fig.4 Store the equipment in a place not subject to
freezing temperatures.
the machine shall be discon-
Do not spray the appliance