UWS Heaty Racun 300 Advanced Plus Bedienungsanleitung Seite 41

Heaty Racun 300 Advanced Plus | Safety instructions
2.5.2 Dangers from hot surfaces
Parts of the device heat up during operation. There is a risk of burns if there is
direct contact with hot surfaces. To avoid this, please observe the following safety
instructions:
• Do not touch hot pipes or the housing of the circulation pump when the
device is switched on. Do not do so until it has been switched off and cooled
down.
• Wear suitable protective gloves when touching or working on hot parts.
2.5.3 Dangers from electricity
The device is powered by electricity. Touching live components can result in serious
injury or death. To avoid this, please observe the following safety instructions:
Disconnect the main power supply before working on electrical equipment
• Disconnect the main power supply before working on electrical equipment.
• Make sure that the power cable is equipped with an appropriate locking
device for maintenance purposes (lockout-tagout).
Liquids
• Be careful when handling liquids. Penetrating liquids can cause a short circuit
or an electric shock.
Connection data
• Observe the specified electrical connection data (see section "8 Technical
data" on page 55).
Covers of electrical components
• Do not open the covers while the device is switched on or in operation.
• Do not remove covers when wiring or checking, even when the power is
turned off.
14
Safety instructions | Heaty Racun 300 Advanced Plus
2.5.4 Dangers when handling the circulation pump
The device uses a circulation pump, which poses various hazards. Around
To avoid property damage and injury, observe the following safety instructions:
• Use the device only in accordance with the technical data (see section
"8 Technical data" on page 55).
• Do not use the device to transport flammable or dangerous liquids.
• Do not leave the device unattended during operation or ensure that unau-
thorized persons do not have access to the device.
• Before carrying out any maintenance or servicing work, switch off the device
and unplug it from the power socket.
• Do not operate the device with the ball valves at the inlet and outlet of the
device or the composite container closed.
• Check the area around the device for leaks and remove any leaking fluids.
• Protect the pump from environmental influences such as splash water or
dust.
2.5.5 Dangers from operating materials
The device contains a mixed bed resin that must be replaced regularly. Contact with
skin or eyes may cause irritation and even visual disturbances. To avoid this, please
observe the following safety instructions:
• Please note the information in the safety data sheet.
• Wear appropriate personal protective equipment when working to avoid
skin and eye contact with the mixed bed resin:
- safety goggles
- Protective gloves
.
15