Improper Use; Transport; Hazards During Operation And Maintenance; Mechanical Hazards - Uws Heaty Racun 300 Advanced Plus Bedienungsanleitung

Heaty Racun 300 Advanced Plus | Safety instructions
• Maintenance and repair
General inspection and cleaning work must be carried out by trained per-
sons. Maintenance, servicing and repair work may only be carried out by
qualified specialists.

2.3 Improper use

The device may only be used in the manner described in section "2.2 Intended use"
on page 10. Any use other than that specified may result in danger to persons and
property and is prohibited.
Improper uses include:
• Use for purposes other than initial filling with water and the treatment of
water in heating systems and cooling systems (without inhibitors)
• Operation in potentially explosive areas in accordance with the ATEX Direc-
tive
• Operation with defective or missing safety devices
• Maintenance and repair in the absence of safety equipment without increa-
sed safety measures
• Operation by unqualified or insufficiently qualified personnel
2.4 Dangers during transport and installation

2.4.1 Transport

During transport and installation of the device, dangers may arise from heavy and
tipping parts. To avoid this, please observe the following safety instructions:
• Transport the device without impact or shock.
• During transport, secure the device using suitable means to prevent it from
tipping over or falling over. Do not remove any transport safety devices until
after installation.
2.4.2 Installation
The device may only be installed by authorized and trained specialists. Improper
installation may result in injury. To avoid this, please observe the following safety
instructions:
• Wear suitable personal protective equipment while working (see section
"2.6 Personal protective equipment" on page 16).
12
Safety instructions | Heaty Racun 300 Advanced Plus
• Do not place heavy objects on the device.
• Place the device on a level and sufficiently stable surface.
• When connecting the device to the power supply, make sure that the mains
voltage corresponds to the information on the type plate.
• Have the device connected to the power supply and earthed by qualified
personnel in accordance with national regulations.
• Use an omnipolar switch with a gap of at least 3mm between the contacts to
connect the device to the power supply.
• Install a high-sensitivity differential switch (0.03 A) for additional protection
against electric shock.
• Lay cables and hoses so that they do not pose a tripping hazard.
• If tripping hazards cannot be avoided, mark them clearly.
• Carry out adjustments or simple repairs in consultation with the manufactu-
rer.
• Do not make any modifications to the appliance or to the water and electri-
city lines.
• Position the device so that the circulation pump motor is sufficiently ventila-
ted.
2.5

Hazards during operation and maintenance

2.5.1 Mechanical hazards

The device consists of moving or heavy components.
Persons may be injured as a result. To avoid this, please observe the following safety
instructions:
• Be careful when replacing heavy parts:
- Wear suitable safety shoes.
- Secure the device against tipping or slipping.
• When carrying out maintenance work on supplied components, please ob-
serve the relevant documentation from the relevant manufacturers.
• Do not place your hands on rotating or moving parts of the device while it is
in operation.
13