Regular Internal Audit; Spare Parts And Accessories; Dismantling And Disposal; Specialist Personnel - Uws Heaty Racun 300 Advanced Plus Bedienungsanleitung

Heaty Racun 300 Advanced Plus | Maintenance and repair

6.3 Regular internal audit

Certain parts of the device are additionally checked at regular intervals
and maintained:
• recirculation pump
• measuring probes LF 1 and LF 2
• output filter cartridge
• flow meter
• Pressure sensors for differential pressure measurement of filtration
The inspection dates must be coordinated by the operator.
NOTE
manufacturer's service
The components are usually firmly connected to the device and may not be
replaced by the customer themselves. In case of errors or malfunctions, ple-
ase contact the manufacturer's customer service.

6.4 Spare parts and accessories

The following spare parts and accessories are available for the device from the ma-
nufacturer:
Item No. designation
100041 funnel
100047-1 measuring case "PROFI"
Refill pack 23 l mixed bed resin (Vadion pH Control, 3 pieces required for
100055
complete refill)
300900 UWS filling combination 1/2" including system separator
100519 Composite container Heaty 300 without head / empty hot water
100462-1 mechanical seal for pump
100462-2 seal set for pump hydraulics
100462-4 Pump set UWS Heaty Racun 300 Advanced / Advanced Plus
100481 Replacement filter for UWS Heaty Racun 300 Advanced / Advanced Plus (2 pcs.)
100481-1 2-way head UWS Heaty Racun 300 Advanced / Advanced Plus
100481-2 Connection UWS Heaty Racun 300 / Advanced / Advanced Plus
52
Dismantling and disposal | Heaty Racun 300 Advanced Plus
7

Dismantling and disposal

CAUTION
The device may only be dismantled by authorized and qualified personnel
who are familiar with the hazards involved.
NOTE
Regulations and laws
Observe local regulations and laws regarding the disposal of environmen-
tally harmful substances.
• The device may only be dismantled by authorized personnel.
• Please observe the safety instructions in the operating instructions in section
"2 Safety instructions" on page 10.
• Do not touch any live components.
• Wear appropriate personal protective equipment.
• Only use suitable and tested lifting equipment.
Injuries can be caused by:
• Live components
• Heavy components that fall down after being loosened
• Sharp edges

7.1 Specialist personnel

The specialist staff must take the following points into account:
• Please observe the safety instructions in this operating manual.
• Wear appropriate personal protective equipment.
• Only use suitable and tested lifting equipment.
• Use suitable means of transport and keep the transport routes free.
• Before starting work, switch off the device and disconnect it from the power
supply.
53