Safety Instructions; General Instructions; Intended Use - Uws Heaty Racun 300 Advanced Plus Bedienungsanleitung

Heaty Racun 300 Advanced Plus | Safety instructions
2

Safety instructions

The Heaty Racun 300 Advanced Plus device was designed and manufactured in
compliance with applicable legal regulations and recognized safety rules. The de-
vice corresponds to the state of the art at the time of its initial commissioning.
However, dangers may arise for the operator, for other persons, for the device itself
and for other material assets.
NOTE
To ensure safe use of the device, please observe the safety instructions in
this section and the warnings in other sections of this operating manual.

2.1 General instructions

The device may only be installed, operated and maintained by qualified personnel
who have received safety training.
Persons involved in the commissioning, operation, maintenance, repair, dismantling
and disposal of the device must have read and understood the operating instruc-
tions and in particular the safety instructions.
The operating instructions must be kept carefully and be available at all times to
persons working with or on the device.

2.2 Intended Use

In order to use the device as intended, it is necessary to be familiar with the opera-
ting instructions and to comply with all the information, maintenance and inspection
regulations contained therein.
10
Safety instructions | Heaty Racun 300 Advanced Plus
DANGER
Danger to life or risk of serious injury
Mechanical and electrical hazards occur when operating the device. To pre-
vent personal injury due to these hazards, you must only use the device as
intended.
The device may only be used as intended as follows:
For initial filling with water and for permanent treatment of water in the bypass pro-
cess of heating and cooling systems (without inhibitors). The following additional
provisions apply:
• Heating and cooling systems
The device is intended for heating and cooling systems (without inhibitors)
in larger residential complexes and industrial buildings. Different device
types are available, which must be selected depending on the system size
(see section "8 Technical data" on page 55).
• Other tasks
In addition to initial filling and preparation, the device performs the fol-
lowing additional tasks:
- leak monitoring
- magnetic filtration
- sludge or dual filtration
- monitoring of conductivity and pressure conditions
- pressure-controlled make-up (optional)
• Filling
The device may only be filled and operated with the mixed bed resin Vadion
pH-Control.
• Operation
The device may only be operated and maintained by persons who are suffici-
ently qualified and authorized.
• Safety devices
The device may only be operated with intact safety devices. Safety devices
must be checked regularly to ensure they are in correct condition and func-
tioning properly.
11