Medela Magic InBra Gebrauchsanweisung Seite 15

3.
Tunnel light is on to help you align the nipple.
5.
When the milk is detected,
7.
the pump will switch from
the Stimulation to the
Expression phase. The +
button will be flashing while
the vacuum is ramping up.
A small noise will be heard
when the system fills with
milk. This is normal.
Solid white: Milk detected
Information
• In both Stimulation and Expression phase, the + button and the - button are lit up only when it is
possible to adjust the vacuum higher or lower. When the lowest or the highest vacuum level is
already reached, the breast pump indicates it with one short vibration.
• Please note, for your comfort, the highest vacuum levels in the Expression phase are available
only when there is milk expressed.
• The breast pump will switch automatically to the expression phase as soon as milk is detected. If
no milk is detected, the breast pump will switch to the Expression phase after 2 min of pumping
in the Stimulation phase. If after 15 min of pumping no milk has been detected the pump will
pause automatically.
• Magic InBra ™ should not be used while lying down, or engaging in strenuous exercise. The
pump will notify with two short vibrations and milk status indicator flashing yellow when there is
a risk of leakage.
Position the
pump on your
breast.
Ensure that
your nipple is
centered in the
breast shield
tunnel.
Secure the pump
in place by
hooking nursing
bra flap over the
pump or by
adjusting the bra
strap.
4.
Tunnel light will switch off after 10 sec of pumping.
6.
8.
Hold the pump
firmly against your
breast and press the
Start/Pause button.
The pump begins in
the Stimulation
phase. The + button
will be flashing while
the vacuum is
ramping up.
Adjust the vacuum
with the + button
or the – button.
There are 5 levels
available in the
Stimulation phase.
Adjust the vacuum
with the + button
and the – button to
your Maximum
Comfort Vacuum
level.
There are 10 levels
available in the
Expression phase.
15