10.2 Realigning the nipple or switching the side
16
If you need to realign the nipple or switch the side while there is already milk expressed follow the
steps in section 10.3 to confirm all the milk is collected into the container. Empty the milk from the
container before switching the side and starting a new pumping session.
10.3 Finishing your pumping session
Information
The maximum volume of the container is 150ml. To avoid the container overflowing, it is
recommended to finish your pumping session when the milk fill level reaches the max line on the
container (130ml). Please note that up to 20ml will be in the breast shield tunnel until collected into
the container during step 3 and 4.
1.
3.
If you need to realign the nipple or switch the side when milk has not
yet been expressed:
1. Pause the breast pump by pressing the Start/Pause button.
2. Break the latch with your fingers.
3. Switch the side (if needed) and press the Left selection button or the
Right selection button accordingly.
4. Realign the breast pump on your breast.
5. Resume pumping by pressing the Start/Pause button again.
For finishing, first
press the Start/
Pause button
.
A slight vacuum
remains to prevent
leakage.
Hold the pump as
shown in the image
while removing it
from your breast.
There will be milk
in the breast shield
tunnel.
2.
Place the pump on a flat
4.
surface in a horizontal
position for a few seconds.
The tunnel light will flash
and the remaining milk
from the breast shield
tunnel will drain into the
container. The pump will
switch off automatically.
Unclip your bra
supporting the
pump against your
breast. Lean forward
and break the latch
with your fingers to
gently release your
nipple from the
pump.