Assembling Your Breast Pump - Medela Magic Inbra Gebrauchsanweisung

9. Assembling your breast pump

CAUTION
To keep the pump parts clean and hygienic:
" Wash your hands thoroughly with soap and water before touching
any part of the Magic InBra
" Dry your hands with a clean hand towel or a single-use paper towel.
" Avoid touching the inside of the milk containers and lids.
To avoid health risks and reduce the risk of injury:
" Before each use, visually inspect the individual components for cracks, chips, tears, deterioration
and cleanliness. In the event of damage, refrain from using the Magic InBra
the defective part(s) has been replaced.
" Only use clean and dry parts for assembly. Refer to chapter 8 for cleaning.
1.
1
2
3.
5.
7.
motor unit
# breast pump or breasts.
Assemble the yellow
valve securely on the
container lid.
1. Engage the top hook.
2. Push firmly at the
bottom to engage the
bottom hook.
Close the
container lid by
pushing it firmly
against the
container.
Push the yellow
membrane against
the container lid to
fit it evenly in the
groove.
Insert the
click
breast shield
into the motor
unit and press
it in on both
sides until it
clicks into
place.
2.
click
4.
6.
8.
# breast pump until
Engage the
hinge of the
container lid to
the container.
The yellow
valve faces the
inside of the
container.
Slide the spout
lid along the
groove to the
closed position.
Ensuring that the
flap is in the
correct position,
place the grey
shield valve on
the breast shield
of your size.
Place the closed
container against
the motor unit so
that the two drop
icons are aligned.
Rotate the
container clockwise
to attach it.
13