Washing And Disinfecting - Medela Magic Inbra Gebrauchsanweisung

8.2 Washing and disinfecting

Washing and disinfecting are two different activities. They must be done separately to protect you
and your baby, and to maintain the performance of your breast pump.
Wash (before first use and after each use)
– to clean the parts by physically removing
milk residues and other possible
contaminants.
12
2
1
1. Rinse the disassembled parts, except for the
motor unit, with cold water (approx. 20 °C).
2. Wash the parts thoroughly with plenty of
warm, soapy water (approx. 30 °C).
Use a mild dish soap.
3. Rinse the parts with cold water for
10 to 15 seconds (approx. 20 °C).
1
1. Wash in dishwasher. Place on the top rack or
in the cutlery section in an orientation that
prevents the parts from collecting water.
Use a commercially available detergent.
2. Rinse the soft silicone parts (the yellow
membrane, the grey shield valve and the
yellow valve) under running water after
dishwashing.
Dry – allow the washed and disinfected parts to completely dry before using or storing them.
3
OR
2
Disinfect (before first use and once per
+
day after use) – to effectively lower the
number of germs that may be present on
the surfaces of the washed parts.
Boil the washed parts for at least 5 minutes.
Make sure the parts are fully immersed in water
and that they are not in direct contact with the
bottom of the pot.
Disinfect in microwave using Quick Clean
bags in accordance with the instructions
on the bags.
* Refer to local website/shops for availability in
your country.
Allow the parts to air-dry on a clean and dry
dish towel or paper towel. It is important that
all residual moisture dries completely.
5 min
OR
™ *