Evolution EVO200 ENGINE Originalanleitung Seite 15

on o
o on
Fig 12
Fig 13
Fig 14
Fig 15
1. Starting your EVO-SYSTEM Engine
Note: A visual safety check should be carried out before attempting
to start the engine. Particularly check for any fuel or oil leaks, the
integrity of accessory attachment and the stability of the machine.
Rectify any faults found before attempting to operate the machine.
• Ensure that the transportation wheels are locked by applying
the wheel brake.
• Turn the fuel tap lever to the 'On' position. (Fig. 11)
• Set the choke lever to the 'Choke On' position. (Fig. 12)
• Turn the engine ignition switch to the 'ON' position. (Fig. 13)
• Steady the EVO-SYSTEM Engine by holding the external
frame at a convenient point.
• Use your other hand to grip the recoil starter cord handle. (Fig. 14)
• Pull the recoil starter cord slowly until resistance is felt
indicating that the starter is engaged.
• When resistance is felt pull the cord sharply.
• Continue this procedure until the engine starts.
• Usually the choke can be returned to the 'off' position almost
immediately when the engine fires up, but this will depend
upon ambient temperatures, operating conditions etc and
operators discretion will be required. (Fig. 15)
Note: When using the generator accessory the engine must be
run at 3150 min the factory set governed speed.
-1
2. Stopping your EVO-SYSTEM Engine
Note: The procedure for stopping the engine can be influenced by
the accessory that is connected.
If the generator accessory has been connected to the engine, it
is important that before stopping the engine all electrical loads
are disconnected from the generator AC outlet sockets. Failure to
do so may cause damage to any connected appliances. See the
relevant 'Instruction Manual(s)' for any specific requirements or
advice regarding machine shut down.
www.evolutionbuild.com
®
EN
15