Westermann Cleanmeleon 2 PRO Betriebsanleitung Seite 146

11
Operation
11.2 Stop
To stop the machine engine, proceed with the operating steps below.
1. Stop the engine.
✓ Turn the ignition key to the "Stop" position.
11.3 Running-in period
The first 50 operating hours greatly influence the performance and service life of the
CM2 PRO.
The following aspects should be taken into consideration to ensure a long service life
of the machine:
The engine can be operated at maximum speed right from the start, but loads
✓
that are too heavy should be avoided.
Stalling of the engine must be avoided at all costs!
✓
✓ Check fluid levels (oil, ...) frequently during the running-in period and check for
leaks.
Check nuts, bolts and screws etc. repeatedly and retighten them if necessary.
✓
Pay particular attention to wheel bolts!
Only use clean fuel.
✓
11.4 Short engine running time
The oil level must be checked regularly when the engine is running for short periods
(no longer than 15 minutes)! With short running times, water and fuel can quickly
leak into the oil, significantly reducing the lubricating effect of the oil. As a result,
parts wear out more quickly, creating a high risk of engine damage. It is therefore
advisable to change the engine oil at regular intervals for short engine running times
or to run the engine once or twice a week for half an hour prevent it from only running
when cold.
34
Proper maintenance is crucial for the operational safety of
the vehicle.