Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the password was correct, [Connected] appears and the WLAN
>
signal bar
20.1.1.2
Configuration via WPS push function
This establishes a direct connection to the router. It is not necessary to select and/or
enter the Wi-Fi network (SSID) and password.
Select [WLAN WPS push button] and press the OK button to start the
>
connection process.
>
Then start the WPS function on your router according to its operating
instructions.
20.1.1.3
Manual configuration
Select [Set manually] and then [Wireless] to start the manual configuration.
>
>
Now select whether you want your router to retrieve the IP address, gateway
etc. automatically (DHCP active) or enter them manually (DHCP inactive).
Please note that the automatic retrieval of the IP address, gateway and subnet
mask only works if the DHCP function is activated in your router.
>
Enter the IP address, subnet mask, gateway address, primary DNS and, if
necessary, secondary DNS one after the other using the arrow buttons on
the remote control. Confirm each set value with the OK button.
>
Now enter the name (SSID) of your WLAN network using the virtual
keyboard and confirm by selecting OK.
Select whether your WLAN network has no encryption, WEP or
>
WPA/WPA2 encryption and confirm the following point.
>
Finally, enter your WLAN password using the virtual keyboard and
confirm by selecting OK to start the connection process.
As a rule, the WLAN connection can be used after a few seconds.
20.1.1.4
Show settings
Select [Network info] to display the current network settings.
>
20.1.1.5
TechniSat Connect PIN
You can control the DIGITRADIO 4 IR with the TechniSat CONNECT App. To do this,
the PIN of the DIGITRADIO 4 IR must be entered in the app. You can change the PIN
here as follows.
36
appears in the status bar of the display.
Werbung
