Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.5 Connect K opfflörer
ATTENTION: Hearing damage!
Do not listen to music at high volume through headphones. This can lead to permanent
hearing damage. Before using headphones, set the device volume to the minimum level.
Only use headphones with a 3.5 millimetre stereo jack plug.
Insert the plug of the headphones into the headphones socket (3) of the
>
DIGITRADIO 4 IR. The sound is now reproduced exclusively via the
headphones, the loudspeakers are muted.
>
If you want to listen via the speakers again, unplug the headset from
the headset socket on the device.
6 General device functions
You can carry out settings and functions using the buttons on the appliance as well
as the remote control. The buttons on the remote control are used to operate the
device as described in these operating instructions.
6.1 Operating the device with the remote control
You can use the infrared remote control to operate the most important functions of the
appliance from the comfort of your seat. Please note the following points when
operating the appliance with the remote control:
Point the remote control at the IR receiver (3) on the front of the appliance.
>
>
There must be a line of sight between the remote control and the IR receiver.
>
If the range of the remote control decreases, the BaGeries should be
replaced with new ones.
The maximum range is approximately 5 metres in front of the device.
6.2 Switch on the device
By pressing the VOL/STANDBY rotary knob (4) on the appliance or
>
On/Standby (26) on the remote control, you can switch the appliance on or
back to standby.
After switching on for the first time, you must first configure the initial
installation wizard. You can find more information on this in chapter "8
Initial setup" on page 19.
6.3 Switch off the device
You can switch the appliance to standby by pressing the VOL/STANDBY
>
rotary knob (4) on the appliance or
control. The date and time appear on the display.
16
On/Standby (26) on the remote
Werbung
