Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If no station is found, check the antenna and change the installation location if
necessary (point 5.2).
15.3.1 Manual search
This menu item is used to check the reception channels and can be used to align
the aerial. If new stations are found on a frequency, these are now also added to
the station list.
Press the MENU button and use the ▲ ▼ buttons to select [Search
>
settings] > [Man. settings] and press the OK button.
Use the ▲ ▼ and OK buttons to select a channel (5A to 13F). The signal
>
strength is now shown on the display. If a DAB+ signal is received on a channel
-transmitter is received, the ensemble name of the transmitter is displayed. The
antenna can now be aligned for maximum signal strength.
Transmitters whose signal strength is below the required minimum signal
strength (see point 15.8) do not transmit a sufficient signal. If necessary, align
the telescopic antenna as described in section 5.2.
15.4 Select channel list
>
Press the
channels.
Alternative:
Open the menu and use the ▲ ▼ buttons to select the menu item
>
[Channel list] and press the OK button.
Depending on the setting under MENU > [Scan settings] > [Change channel],
the OK button must then be pressed in the channel list to play the selected
channel (option: Change channel > List) or the channel is played
automatically (option: Change channel > Channel).
15.5 Saving DAB+ stations
The favourite memory can store up to 30 DAB+ stations.
The saved transmitters are retained even after a power failure.
>
Play the desired station.
Press one of the number buttons 0 ... 9 on the remote control and hold it
>
down until [Favourite x saved] appears on the display. The number
button 0 is the favourite memory location 10.
>
Saving additional transmitters: Repeat the process.
Alternatively and for memory locations 11 ... 30:
Press and hold the FAV button, use the ▲ ▼ buttons to select a
>
favourite memory location 1...30 and press the OK button.
26
▲ or
▼ buttons to switch between the available
Werbung
