Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.3 Connecting the power supply unit
WARNING!
Do not touch the mains plug with wet hands, risk of electric shock.
Blow!
ATTENTION!
Lay the mains cable so that nobody can trip over it and the power supply unit can
be reached quickly at any time to disconnect the appliance from the mains.
Notes:
-
Make sure that the operating voltage matches the local mains
voltage before inserting the mains plug into the wall socket.
-
Use a suitable, easily accessible mains connection and avoid using
multiple sockets!
-
In the event of faults or smoke and odours coming from the housing, pull
the mains plug out of the socket immediately!
-
If the appliance is not to be used for a longer period of time, e.g. before
travelling, unplug the mains plug.
Connect the DC plug of the power supply unit to the socket labelled DC-IN
>
(13) on the back of the DIGITRADIO 4 IR.
>
Insert the mains plug into a mains socket.
5.4 Inserting batteries into the remote control
Notes: Observe the point "Handling BaGeria" in the safety instructions.
To operate the remote control, you need 2x alkaline batteries, type Micro, 1.5 V,
LR03/AAA. Make sure the polarity is correct when inserting the batteries.
Replace weakening BaGeries in good time.
>
Open the battery compartment on the back of the remote control by sliding it
in the direction of the arrow.
>
Insert the batteries (2x AAA 1.5V) according to the polarity shown
in the battery compartment.
>
Carefully close the assembly compartment cover again so that the
retaining tabs of the cover engage in the housing.
15
Werbung
