Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the connected audio source does not provide a signal for 15 minutes, the
device automatically switches to standby.
19 Further functions
19.1 Sleep timer
The sleep timer automatically switches the DIGITRADIO 4 IR to standby after the set
time.
Press the MENU button and use the ▲ ▼ buttons to select the
>
[Sleep timer] entry.
Press the OK button.
>
Use ▲ ▼ to select a time period after which the DIGITRADIO 4 IR should
>
switch off. You can choose between Off, 5, 10, 15, 30, 60 and 90
minutes.
Press the OK button to accept the setting.
>
Alternatively, you can also use the SLEEP button
>
to set the switch-off time.
A moon symbol appears on the display with the remaining time until the
DIGITRADIO 4 IR is switched off.
19.2 Alarm clock
The alarm clock switches the DIGITRADIO 4 IR on at the set alarm time. Two alarm
times can be programmed. The programming of alarm clock 1 is described below as
an example.
19.2.1 Set up alarm clock
You can only operate the alarm function once the correct time has been
set. Depending on the configuration, this is done automatically or must be
set manually. The time can be updated either manually, via DAB+/UKW or
via the Internet. Further information on this can be found in chapter 20.2.
Press the Alarm clock button (32) on the remote control.
>
The overview of the set alarm times appears on the display.
Use the ▲ ▼ buttons to select one of the alarm clock memories
>
that you would like to set and press the OK button.
>
The individual alarm clock parameters can then be set one after the other.
Press the OK button to open an alarm clock parameter and use the ▲ ▼
buttons to change it.
32
. Press it several times
Werbung
