Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If an FM station with a sufficiently strong signal is found, the search
stops and the station is played. If an RDS station is received, the station
name and, if applicable, the radio text will appear.
To tune to weaker stations, please use the manual station search.
16.4 Set the transmission frequency manually
>
Briefly press the
desired station or frequency.
The display shows the frequency in steps of 0.05 MHz.
16.5 Search setting
The sensitivity of the search run can be set in this menu item.
Press the MENU button and use the ▲ ▼ buttons to select the
>
[Search settings] entry and press the OK button.
Select whether the search should only stop for strong channels [Only
>
strong channels?] ([Yes]) or for all channels (also for weak channels
> [No]).
If [No] is set, the automatic search stops at every available station. This
can result in weak stations being played back with noise.
16.6 Audio settings
Press the MENU button and use the ▲ ▼ buttons to select [Sound
>
settings] > [Audio output] and press the OK button.
Use ▲ ▼ to select the entry [Stereo possible] or [Mono only] to
>
enable playback in stereo or only in mono sound when FM reception is weak.
to reproduce.
Confirm by pressing the OK button.
>
16.7 Saving FM stations
The favourites memory can store up to 30 FM stations.
The saved transmitters are retained even after a power failure.
>
Set the desired channel.
Press one of the number buttons 0 ... 9 on the remote control and hold it
>
down until [Favourite x saved] appears on the display.
>
Saving additional transmitters: Repeat the process.
Alternatively:
Press and hold the FAV button, use the ▲ ▼ buttons to select a
>
favourite memory location 1...30 and press the OK button.
▲ or
▼ buttons several times to set the
29
Werbung
