Parkside Performance PPKSA 40-Li B2 Originalbetriebsanleitung Seite 58

GB MT
creased tendency of kickback by the
machine.
Tools and aids required
• Round file
• Flat file
Procedure (Fig. S)
1. Switch off the device and remove
the batteries.
2. Ensure that the saw chain is
tightly tensioned to enable correct
sharpening.
3. Only sharpen from the inside out.
Guide the round file from the in-
side of the cutting tooth to the out-
side. Lift off the file when you pull
it back.
4. Sharpen the teeth on one side
first. Then turn the saw chain over
and sharpen the teeth on the other
side.
5. Check the length of the cutting
links. After sharpening, all the cut-
ting links must have the same
length and width.
6. After every third sharpening, check
the sharpening depth (depth
gauge) and re-file the height using
a flat file. The depth gauge should
be set back by approx. 0.65 mm
from the cutting tooth.
7. After resetting, round off the depth
gauge slightly towards the front.
Adjusting the chain tension
Adjusting the chain tension is de-
scribed in section Tensioning the saw
chain, p. 51.
Running in a new saw chain
The tensioning force of a new saw
chain decreases after some time.
You must therefore retighten the saw
chain after the first 5 cuts or after 10
minutes of sawing at the latest (Ten-
sioning the saw chain, p. 51).
58
WARNING! Risk of injury! Nev-
er attach a new saw chain to a worn
chain sprocket or to a damaged or
worn blade bar. The saw chain could
jump off or break.
Servicing the blade bar
CAUTION! Cutting injuries! Wear
cut-resistant gloves when working
with the saw chain or with the blade
bar.
Tools and aids required
• Flat file
Procedure (Fig. B)
1. Switch off the device and remove
the batteries from the device.
2. Remove the sprocket cover (14),
saw chain (6) and blade bar (7).
3. Check the blade bar (7) for wear.
4. Remove burrs and straighten the
guide surfaces with a flat file.
5. Clean the oil passage (35) to en-
sure fault-free, automatic oiling of
the saw chain during operation.
6. Mount the blade bar (7), saw chain
(6) and sprocket cover (14) and
tighten the chainsaw.
When in an optimal condition, the
oil passages will automatically spray
the saw chain with a little oil a few
seconds after starting the chainsaw.
Turning the blade bar
CAUTION! Cutting injuries! Wear
cut-resistant gloves when working
with the saw chain or with the blade
bar.
The blade bar (7) needs to be re-
versed regularly after a working time
of about 10 hours in order to ensure
even wear.
Procedure (Fig. B)
1. Switch off the device and remove
the batteries from the device.
2. Remove the sprocket cover (14),
saw chain (6) and blade bar (7).