Cleaning, Maintenance And Storage; Cleaning; Maintenance - Parkside Performance Ppksa 40-Li B2 Originalbetriebsanleitung

GB MT

Cleaning,

maintenance and
storage
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
WARNING! Risk of injury! Always
switch off the motor and let it cool
down, then remove the batteries be-
fore any cleaning work.
CAUTION! Cutting injuries! Wear
cut-resistant gloves when working
with the saw chain or with the blade
bar.
NOTICE! Risk of damage. Chemic-
al substances may attack the plastic
parts of the machine. Do not use any
cleaning agents or solvents.
Clean the machine thoroughly. This
will extend the life of the machine and
prevent accidents.
Cleaning after every use
• Keep the handles free of petrol, oil
or grease. If necessary, clean the
Machine part
Chain brake
components
Sprocket (23)
Saw chain (6)
Saw chain (6)
56
Action
Visual inspection,
replace as needed
Visual inspection,
replace as needed
Check saw chain, oil, reg-
rind or replace if necessary
Clean and oil the saw chain
handles with a damp cloth washed
in soapy water.
• Clean the saw chain. Do not use
any liquids to clean the saw chain.
Lightly oil the saw chain with chain
oil after cleaning.
• For cleaning, also remove the
sprocket cover (14) so that this
area can also be cleaned.
• Clean the blade bar (7)
• Clean the ventilation slits and the
surface of the machine with a
paintbrush or dry cloth.
• Clean the oil passage (35) to en-
sure fault-free, automatic oiling of
the saw chain during operation.
Use a brush or a cloth to help re-
move residues from the oil pas-
sage.

Maintenance

Service intervals
Carefully perform the maintenance
tasks listed in the following table on
a regular basis. Regular servicing of
your device will extend its life. Ad-
ditionally, you will achieve optimum
cutting performance and prevent ac-
cidents.
Before After 10
each use
✓
✓
✓
After
hours each use
of use
✓