Safety Information; Meaning Of The Safety Information - Parkside Performance Ppksa 40-Li B2 Originalbetriebsanleitung

Type of battery .......................... Li-Ion
PARKSIDE Performance Smart
battery Smart PAPS 204 A1/
Smart PAPS 208 A1
– Operating frequency/Frequency
band .....................2400 - 2483.5 MHz
– transmitted power ............≤ 20 dBm
Levels of noise and vibration were de-
termined according to the standards
and regulations in the declaration of
conformity.
The specified total vibration value and
the stated noise emission value have
been measured according to a stand-
ardised test method and can be used
to compare one power tool with an-
other. The specified total vibration
value and the stated specified noise
emission value can also be used for a
provisional assessment of the load.
WARNING! The vibration and
noise emissions may deviate from
the specified values during actual
use of the power tool, depending on
how the power tool is being used. Try
to keep the exposure to vibrations
as low as possible. An example of a
measure to reduce vibration expos-
ure is limiting the working hours. All
parts of the operating cycle have to
be considered while doing so (for ex-
ample, times when the power tool
is switched off and times when it is
switched on but running without any
load).
X 20 V TEAM
The device is part of the
X 20 V TEAM series and can be
operated with batteries of the
X 20 V TEAM series. Batteries of
the X 20 V TEAM series may only
be charged using chargers of the
X 20 V TEAM series.
We recommend that you oper-
ate this appliance with the fol-
lowing batteries only: PAP 20 A1,
PAP 20 A2, PAP 20 A3, PAP 20 B1,
PAP 20 B3, Smart PAPS 204 A1,
Smart PAPS 208 A1,
Smart PAPS 2012 A1
We recommend charging these bat-
teries with the following chargers:
PLG 20 A1, PLG 20 A2, PLG 20 A3,
PLG 20 A4, PLG 20 C1, PLG 20 C3,
PDSLG 20 A1, PDSLG 20 B1,
PLG 201 A1, Smart PLGS 2012 A1
Rechargeable battery and charger
technical data: See separate manual.

Safety information

This section deals with the basic
safety instructions for using the
device.
WARNING! Injury and property
damage due to improper handling of
battery. Observe the safety informa-
tion and notes on charging and prop-
er use as shown in the instruction
manual for your battery and charger
from the series X 20 V TEAM. A de-
tailed description of the charging pro-
cess and further information can be
found in these separate operating in-
structions.
WARNING! A chainsaw is a dan-
gerous piece of equipment that can
cause serious or even fatal injuries if
used incorrectly or carelessly. There-
fore, for your safety and the safety of
others, always observe the following
safety instructions and ask an expert
for advice if you are unsure.
Meaning of the safety
information
DANGER! If you do not observe
this safety instruction, an accident will
occur. The result of which is severe
bodily injury or death.
GB MT
39