Checking The Battery Charge Level; Charging; Charging The Battery - Parkside Performance Ppksa 40-Li B2 Originalbetriebsanleitung

Checking the battery
charge level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (19) next to the
charge level indicator button (20)
on the battery (17).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
2. Charge the battery (17) when only
the red LED on the charge level in-
dicator (20) is illuminated.

Charging

WARNING! Injury and property
damage due to improper handling of
battery. Observe the safety informa-
tion and notes on charging and prop-
er use as shown in the instruction
manual for your battery and charger
from the series X 20 V TEAM. A de-
tailed description of the charging pro-
cess and further information can be
found in these separate operating
instructions. WARNING! Risk of
injury caused by leaking electrolyte
solution! Do not expose the battery
to extreme conditions such as heat
and shocks. In case of contact with
eyes or skin, rinse the affected sites
with water or a neutralising agent and
seek medical attention.
WARNING! Risk of injury from
electric shock! Only charge batteries
in dry rooms. The external surface of
the battery must be clean and dry be-
fore being connected to the charger.
• Charge the batteries before using
them for the first time.
Meaning
Battery partially
charged
Battery needs to
be charged
• Always comply with the latest
safety information, as well as the
regulations and information relating
to environmental protection.

Charging the battery

See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (17) from the
device.
2. Push the battery (17) into the char-
ging slot of the battery charger
(21).
3. Connect the battery charger (21) to
a power outlet.
4. After charging, disconnect the bat-
tery charger (21) from the mains.
5. Pull the battery (17) out of the bat-
tery charger (21).
Control LEDs on the charger (21):
green red
lights up —
— lights up Battery is char-
— flashes
flashes flashes
GB MT
Meaning
• Battery is fully
charged
• stand-by (No
battery inser-
ted)
ging
Battery is over-
heated
Battery is defect-
ive
47