Profitec GO Bedienungsanleitung Seite 29

9. Wait briefly after adjusting the temperature. "St" will appear.
6.4.2 Programming the "CLn" group cleaning mode
With the GO, you can program a reminder for the next brew group cleaning via the PID display. The default
setting for the machine is set to 0, so no reminder is programmed yet.
To program the cleaning reminder, please proceed as follows:
Press + and - simultaneously, "t1" appears on the display.
Press the - key until "CLn" is displayed. Press + to enter the CLn menu.
Now you can program in steps of 10, between 0 and 200, by pressing +
and -.
To exit the programming mode, wait until "CLn" appears and then press
the - key.
If you have programmed e.g. 90, you will be reminded to clean the brew
group after 90 brews via the display with a "CLn". (see point 7.2)
We recommend cleaning the brew group after approx. 90 - 140 coffee brews. The "CLn"
function only counts brews that are a minimum of 15 seconds long.
6.4.3 Programming the ECO mode
The ECO mode allows you to set an automatic switch-off after the machine has not been used for a set
time. By default, this value is set to 90 mins. This activates a countdown after the last brewing process,
which will switch the machine off after 90 mins have elapsed.
This countdown runs automatically in the background and is not visible. After the machine has been
switched off by the countdown, it can be activated by pressing the coffee dispensing switch again or by
briefly switching the machine off and on again.
To program the ECO mode, proceed as follows:
1. Switch on the device.
2. Press + and – simultaneously on the PID until "t1" appears on
the display.
3. Press - until "ECo" appears on the display and press + to enter
the ECO menu.
The ECO mode is displayed with ECo as soon as the machine
switches off.
4. ECO mode can be programmed in 30 min steps by pressing +
and -, from 0 to 600 mins.
Translation of the original German user manual
ENGLISH
28